Build Quality
Overall build quality is solid. When shaking the mouse, a rattle comes from an indeterminable location. When applying lateral pressure, no creaking or flexing of the shell can be observed. Activating the side buttons by squeezing the sides is impossible. Lastly, accidental clicks when slamming down the mouse do not occur.
Main buttons on the Model D3 Wireless are good. While pre-travel is low to moderate, post-travel is low, resulting in a fairly firm and snappy button response. Being visually separated from the shell, button movement is moderate when provoked. Button stiffness is medium. A pair of Kailh GO optical switches are used.
Side buttons are very good. Pre- and post-travel are low, leading to pleasant actuation, and the actuation point is even across the entirety of these. Button placement is good as actuation is possible quite easily by rolling one's thumb across. A set of surface-mounted Kailh switches (green plunger) are used for these.
At the top of the mouse is a button for cycling through the set CPI levels, which works fine. Another surface-mounted Kailh switch (green plunger) is used for this one. At the bottom of the mouse is a button for switching between 2.4 GHz wireless and Bluetooth, which will only apply if Bluetooth has been paired. A seemingly unbranded tactile switch is used for this one.
The scroll wheel is good. Noise levels are mostly under control, but tactility is somewhat mediocre, as the individual steps aren't particularly distinct. The encoder comes from Kailh (gray/teal core) and has a height of 15 mm. The middle (scroll wheel) click requires high force for actuation. A seemingly unbranded tactile switch (black plunger) is used for this one.
Surface
The Model D3 Wireless has a matte surface all over. Grip is fine, and it doesn't attract fingerprints or dirt too much. It is fairly easy to clean, and there are no signs of wear left after doing so. All in all, very good materials.
Disassembly
Disassembling the Model D3 Wireless is moderately difficult. Four Torx T6 screws are located beneath the front and rear skates. After removing those, one needs to pull the bottom shell at the front where the USB connector is, which should dislodge all clips except for the back one, as that one will require special attention. Caution needs to be applied when separating the top and bottom shell to avoid ripping the cables connecting the two.
The internal design is fairly efficient. The side buttons sit on their own PCB slotted into a plastic assembly that is part of the bottom shell and connected through an FFC to the main PCB. The Guardian battery is stuck above the sensor. Everything else sits on the main PCB, which is moderately thin and somewhat spacious, and which has been affixed to the bottom with only two screws, allowing one to easily lift it at the front. The MCU is a Nordic nRF52840, whose datasheet is found
here. Production date for the side-button PCB is the 22nd week of 2025, whereas the main PCB has been manufactured during the 23rd week of 2025.
As for the soldering and general quality of the PCB, I'm unable to find any noteworthy flaws.