Value and Conclusion
- Huge capacity
- Decent price
- Tolerant to high operating temperatures
- Silent with output load of up to 500 W
- Efficient with normal loads, and efficiency of over 70% with 2% load
- Hold-up time long enough
- Highly efficient 5VSB rail
- Ripple suppression good enough
- Accurate power ok signal
- ASM compatible
- Low vampire power
- Fully modular
- Cables are long enough
- Plenty of connectors
- Compact dimensions given its maximum output
- 5-year warranty
- No over-temperature protection
- Poor transient response
- Relative performance not competitive
- Gets loud at higher loads
- Low efficiency with light loads (20–80 W and 40–100 W)
- Load regulation at 3.3 V and 5VSB not tight
- No selectable semi-passive operation
- I would like to see 150 mm between peripheral connectors
InWin teamed up with High Power to offer a high-capacity power supply at a reasonable price. The P125 uses quality parts, and build quality is high, but several changes are needed for it to become more competitive in this tough category. For starters, the platform looks outdated with all these cables connecting the modular and main PCB. Besides energy losses, the cables block airflow to the secondary side, requiring the fan to spin faster to cool the sensitive components there. Another major downside is the lack of over temperature protection. I almost melted the cables on the secondary side, and the PSU continued to operate instead of shutting down. Seeing a powerful PSU priced at $250 without over temperature protection is a great shame.
For a 1250 W PSU, the compact dimensions are welcome, but as with anything in life, you cannot have something good without a bad thing following. In this case, the small PCB requires more airflow, which has the cooling fan produce more noise than it otherwise would when the PSU is stressed. Adding to that, the fan-speed profile could be less aggressive at normal operating temperatures. This platform features a semi-passive operation, but doesn't give you the ability to turn it off for the fan to spin at all loads, which would have been better. It is way better to have the fan spinning at light loads, effectively removing heat, than leaving the heat to accumulate, which suddenly forces the fan to spin at high speeds to remove it quickly. A semi-passive operation is not as effective as a PWM-controlled cooling fan, which allows for very low RPM and, as such, minimal output noise at light loads.
Another major problem of this High Power platform is the lousy transient response. Given its huge capacity, someone would expect good results with transient loads, but this is not the case, especially at 3.3 V, where the results are terrible, reminding me of older-generation PSUs. High Power should improve the DC-DC converters of this platform by adding more capacity to cope with transient loads. In-cable caps could also help, but they would make the cables bulky.
The P125 cannot be called bad or even mediocre, but it needs more to compete in this tough category and better its overall ranking in the performance charts. The Thermaltake Toughpower GF1 1200 W is 4% ahead, and the Cooler Master MEW Gold 1250 V2 is 4.18% away. With better transient response and over temperature protection, the P125 would do better, and a more relaxed fan-speed profile would be an excellent addition, too.