Installation
Since the cooler comes with the fans already installed the only thing to worry about is if they are oriented properly for your build. Outside that, check the pre-installed bracket to make sure its fully seated. The review sample here was good to go out of the box. With the preliminary check done, next for AMD systems you will need to remove the black plastic mounting brackets on the motherboard. After that install the proper standoffs.
Next, apply thermal paste to the CPU, for testing I use Arctic's MX6, but make sure to do a better job than I do in the photos. With that taken care of you can slide the pump block over the standoffs and secure it with the including spring screws. Make sure to alternate between them in a crisscrossing pattern often so you're applying even pressure.
Now install the MPG CORELIQUID P13 360's radiator and fan assembly and plug everything in, and you're good to go from a physical standpoint. To make the most of the cooler you will need to install the MSI Center software to have full control over the unit's IPS display.
Overall, the installation is pretty straightforward on AMD and Intel with no issues to speak of. With the fans pre-installed and the mounting hardware being simple and easy to work with it is a very easy AIO to install regardless of platform. It has four mounting points on AMD and Intel which is a plus. The software is intuitive and easy enough to work with however it does have drawbacks that I'll discuss a bit later.