Software
The Lift Elite Wireless is compatible with CAM, which is NZXT's staple software suite. CAM is similar to Corsair iCUE or ASUS Armoury Crate in that it is an all-in-one software package for all NZXT products, including monitoring functions and RGB lighting control. In order for setting changes to be saved to the mouse, one first has to select one of the five on-board profiles.
All settings are presented on a single page. CPI can be adjusted for up to five steps at a range of 100 to 26,000 CPI, either by dragging the slider or inputting values manually, in the latter case of which any non-native values are truncated to native ones. Even though the sensor natively supports CPI adjustment in increments of 50, CAM arbitrarily limits this to increments of 100. In addition, one can enable a warning display when battery charge drops below 5%, as well as enable the option to turn off the mouse after a set period of time of inactivity, though this doesn't work as one would suspect. Essentially, the mouse will actually never turn off but merely sleep, albeit only with this setting enabled. If disabled, the mouse will only turn off when the battery is virtually discharged. Polling rate can be set to 250, 500, 1000, 2000, or 4000 Hz, with an additional 8000 Hz setting that will be truncated to 4000 Hz when wireless. Lift-off distance may be set to 1 or 2 mm. MotionSync may be turned on or off, but this setting has no effect and will default to enabled. A macro editor is included, and button remapping is possible for all but the left and right main buttons to mouse, keyboard, or media functions. Lastly, profile management is included, too.
All settings changes can be saved to the on-board memory, so the software does not need to be running (or be installed) all the time. On my system, the software had a RAM footprint of 288 MB on average along with some CPU cost when running in the foreground, which does not change when minimized to the taskbar or system tray. Upon exiting the application, two processes keep running provided CAM has been launched at least once during a session; otherwise, it will be one.
Battery Life
NZXT cites up to 70 hours of battery life at 1000 Hz. The battery charge indicator also gives an approximation of expected battery life, showing 76 hours at 1000 Hz and 29 hours at 2000 and 4000 Hz. In practice, for every hour of continuous use at 4000 Hz, the indicator went down by 10%, which would amount to roughly 10 hours. Relative to the cited 70 hours at 1000 Hz, one would expect something closer to the 15-hour mark, however.
Using the included USB Type-A to Type-C charging cable, I measured the charging speed during the constant current stage, which sits at 0.344 A when lifted and 0.324 A when not lifted. The battery has a capacity of 300 mAh (4.2 V) and utilizes a 3-pin JST connector.