Sustained Speeds and Preconditioning
Before measuring speed, the SSD must be properly prepared through a process known as preconditioning. This step ensures that performance measurements reflect consistent, sustained behavior. SSDs typically operate in three performance states: Fresh-out-of-box (FOB), a transitional phase, and the steady state.
FOB refers to the initial condition when an SSD is first subjected to workload testing. The transitional phase is the period during which performance begins to decline and stabilize. Steady state is the point where performance levels off and remains consistent, regardless of continued workload.
A simple analogy helps clarify these phases: imagine a marathon runner who starts the race at full sprint, reaching peak speed—let's say 15 km/h. It's unrealistic to maintain that speed for the entire race. As fatigue sets in, the runner slows down. That slowdown represents the transitional state. Eventually, the runner finds a pace that can be sustained for the remainder of the distance—that would be the steady state.
Consumer-grade SSDs exhibit similar behavior but often rely on SLC caching to temporarily boost speeds. In most cases, these drives can't achieve their advertised maximum throughput without such techniques. Enterprise SSDs, on the other hand, are engineered for consistency and typically avoid performance-enhancing caches, maintaining steady speeds under continuous workloads.
Sequential 128 KiB - Write
Starting with the sequential speed test, the SSD delivers as promised, maintaining its rated write speed throughout the entire test while also exhibiting very low latencies.
Random 4 KiB - 100% Write
We will now begin preconditioning the SSD using random 4 KiB write workloads at a queue depth of 256, running for several hours until the drive reaches steady state.
As we can see, the SSD reaches its steady state around the 2000-second mark, maintaining over 460K IOPS, slightly above the manufacturer's specified 450K IOPS and surpassing the 410K IOPS achieved by the Memblaze 30.72 TB we previously tested. However, it still falls behind the 7.68 TB Memblaze SKU, which, like this unit, is rated for 1 DWPD. The only drive to significantly outperform them was the Phison X200E, thanks to its 3 DWPD endurance and much larger overprovisioning, which gives it a notable advantage in sustained performance.
Random 4 KiB - 70% Read and 30% Write
When running the mixed 4 KiB read and write benchmark, we noticed that in steady state, the MonTitan reached an average of nearly 800K IOPS, placing it slightly behind the other Gen 5 SSDs we tested, outperforming only the Gen 4 Dapustor drive. It took approximately 4000 seconds to stabilize at this performance level.