Thursday, February 9th 2012

Aerocool Launches the Strike-X One & Strike-X One Advance PC cases

Taiwan-based Aerocool Advanced Technologies has just announced the European release of two new Strike-X Series mid-tower PC cases, the Strike-X One and Strike-X One Advance. Both models feature a steel structure, are painted black both inside and out, and have support for ATX and micro ATX motherboards, four 5.25-inch drive bays (with tool-free mounting systems), six 3.5-inch internal bays, a PSU dust filter, and pre-drilled holes for watercooling tubes and cables.

The Strike-X One has an I/O panel with two USB 2.0 ports, and is equipped with one 120 mm rear fan, while the Strike-X One Advance comes with two USB 3.0 ports, a 120 mm rear fan, and a front 120 mm fan with red LEDs. The Strike-X One and Strike-X One Advance cost 34.99 Euro and 39.99 Euro, respectively.
Add your own comment

8 Comments on Aerocool Launches the Strike-X One & Strike-X One Advance PC cases

#1
THE_EGG
I'm sure Xigmatek will have something to say about the front panel design...
Posted on Reply
#2
FreedomEclipse
~Technological Technocrat~
THE_EGGI'm sure Xigmatek will have something to say about the front panel design...
I was gonna say Xclio might have a problem with it too but the last time Xclio made a case with an X in it, i was still in highschool
Posted on Reply
#3
THE_EGG
It does look like you get a LOT of kit for the money though. Although the paint on my last Aerocool Case (Aerocool M40), decided to shed its skin after 2 years and I had to repaint it. (although i was planning to repaint it anyway.)
Posted on Reply
#4
_JP_
Why, upon glancing at the 1st image, did I get the feel that something was not right, that this chassis should be orange and Xigmatek?
Posted on Reply
#5
Vancha
_JP_Why, upon glancing at the 1st image, did I get the feel that something was not right, that this chassis should be orange and Xigmatek?
I don't think even Xigmatek could make something look that tacky.
Posted on Reply
#6
pantherx12
I was going to say "not bad" but then I saw the big X on the front.

Way to completely ruin a case.
Posted on Reply
#7
_JP_
VanchaI don't think even Xigmatek could make something look that tacky.
I don't think so either, but it was the 1st that came to my mind.
pantherx12I was going to say "not bad" but then I saw the big X on the front.

Way to completely ruin a case.
You could just chop it off.
Posted on Reply
#8
pantherx12
_JP_I don't think so either, but it was the 1st that came to my mind.

You could just chop it off.
For once I want a case that I don't have to chop up :laugh:
Posted on Reply
May 16th, 2024 18:54 EDT change timezone

New Forum Posts

Popular Reviews

Controversial News Posts