Thursday, September 26th 2013
XFX Radeon R9 280X Double Dissipation Pictured
Although Radeon R9 280X has a lot in common with Radeon HD 7970 GHz Edition, AMD's AIB partners are expected to come up with entirely new board designs. A case in point is the XFX Double Dissipation card, pictured below. While we don't know if XFX is recycling PCB designs over from the HD 7970 GHz Edition, the cooler certainly looks new, with its tall and chunky aluminium fin heatsink that's fed by copper heat-pipes, and a pair of 100 mm fans. Its box speaks of an "unlocked voltage" feature.
Based on the 28 nm "Tahiti XTL" silicon, Radeon R9 280X features 2,048 GCN stream processors, 128 TMUs, 32 ROPs, and a 384-bit wide GDDR5 memory interface, holding 3 GB of memory. The GPU is expected to be clocked a notch above 1.00 GHz on XFX' card, and the memory around 6.40 GHz. Slated for October 3rd, the card is expected to be priced anywhere between $299 and $329.
Source:
VideoCardz
Based on the 28 nm "Tahiti XTL" silicon, Radeon R9 280X features 2,048 GCN stream processors, 128 TMUs, 32 ROPs, and a 384-bit wide GDDR5 memory interface, holding 3 GB of memory. The GPU is expected to be clocked a notch above 1.00 GHz on XFX' card, and the memory around 6.40 GHz. Slated for October 3rd, the card is expected to be priced anywhere between $299 and $329.



55 Comments on XFX Radeon R9 280X Double Dissipation Pictured
The second pic you made reference too,is the motherboard side of the card at the pci-e slot , not exactly where I would put the heatpipes to allow produced heat to trickle up ward along the board to other components .cpu,memory ,other chips ,etc..neither you nor I ,can see whats exposed on the other side.we can guess for now..Going by the cases I have (CM 832 stacker,Thermaltake Kandalf,Antec 1200) and have worked with,(too many too list) the obsidian 800D is roomy and vented as well as most ,with the exception of the antec's,the 600 the 900 and the 1200 are the better vented ,closed cases..largely because of the huge fans up top.but are dirty because of the negative case preasure they creat.they suck dust in every where..i try to find a low positive preasure.on all systems I build so only the fan areas draw air.think of it as a big ol nasty Power House Boiler,:banghead: lol,that was almost as painful to type as it was to read..
Due to the direction the fins on the heatsink run, it would be unwise to block off the sides where the heat can disperse and leave the card. If you compare that to an MSI Twin FrozR though the fins run vertically so air gets channeled out at the front and the back of the card while some may flow out of the sides. They would have to leave the sides of the card exposed otherwise there would be no where for the hot air to go
Cooler performance isn't as good as a Vapor X Toxic but certainly expected to be better than the POS XFX used on the 7950/7970.
Review link:
www.kitguru.net/components/graphic-cards/zardon/xfx-r9-280x-black-oc-edition-review/
Nice thin fins too and i see they have joined them all together too so they don't get bent up as easy.