erocker
*
- Joined
- Jul 19, 2006
- Messages
- 43,592 (6.67/day)
Processor | AMD Ryzen 7 7800X3D |
---|---|
Motherboard | ASUS TUF x670e |
Cooling | EK AIO 360. Phantek T30 fans. |
Memory | 32GB G.Skill 6000Mhz |
Video Card(s) | Asus RTX 4090 |
Storage | WD m.2 |
Display(s) | LG C2 Evo OLED 42" |
Case | Lian Li PC 011 Dynamic Evo |
Audio Device(s) | Topping E70 DAC, SMSL SP200 Headphone Amp. |
Power Supply | FSP Hydro Ti PRO 1000W |
Mouse | Razer Basilisk V3 Pro |
Keyboard | Tester84 |
Software | Windows 11 |
ok i just had xfire up and running just fine (required stock clocks to work) but now nothing i have rebooted shut down and powered back and still no xfire....this is very annoying im on cats 8.4 in XP 32 think i should try cat 8.2?
The 8.4's should work. I would uninstall the drivers and before you reboot, delete the ATi folder on your system drive (default), then go into your Windows folder and find the temp and prefetch folders and delete everything. (If you have disk indexing off, there might not be anything in the prefetch folder). Shut down. Install one card, start-up, install catalyst. Then shut down and install the other card, start-up and XP will basically install the driver for the second card, give it a minute or so... Shut down, install bridges, start up, and go into CCC, enable crossfire and you should be good. Everyone having problems with crossfire should try this method as it works for me with XP and Vista with good success. Another thing is, if you decide for some reason to swap cards from one slot to the other, or just decide to use one card, reinstall your drivers.