my lash together till i get a better case and power supply.. just a big mess as a bit of a joke

dude.. hope to see you get a better case and nice cable mgnt first, then I'll vote for you.. btw. ur hardware is really a nice one.. what's your system temp with all that mess? keep it coming..

legends84dude.. hope to see you get a better case and nice cable mgnt first, then I'll vote for you.. btw. ur hardware is really a nice one.. what's your system temp with all that mess? keep it coming..

yeah im getting an antec 1200 and a 1000W power supply (this case was $90AUS with a power supply, but i replaced it with a coolmaster eXtreme power 550W and its CRAP DO NOT USE THESE the bearing in the fan went after about 3 months (some oil on the bearing has fixed that though) and the 12+ is more like 11.19V at load and i cant even get the cpu volts to what the bios says (its set to 1.47 now and i have 1.36 on load and 1.43 at idle yes the MB is prolly more at fault but not with the 12V))

as for the cable mgnt it was ok till i added the second psu lol

this is more of a joke than anything.

as for the temp cpu is 51°C at the core while running prime95 and the gpu is about 52°C after 10mins with firmark burnmode

you know your cards running at pci-e 2.0 @ x1

DOMyou know your cards running at pci-e 2.0 @ x1

LOL about this...Yeah look GPUZ!!!1x!!!It would be an 8600 not a 8800 that way...;)
As for the 2nd PSU try to fit it under the VGA like in the bottom of the case.I ve done it once and it fitted and u ll route the power cord through one expansion slot...
And then cut the cables from the 2nd psu keeping only the ones u use and from the 24pin only the green wire and a ground...U ll be able to close your case then;)

I voted 10/10 because:

LOVE the Title!

are you using a non conductive water cooling fluid ? if not I highly recommend it.

Wow, all those wires. Be sure to post it again when you're done with it. What's up with that black sys fan in the middle of yr case?

theorwLOL about this...Yeah look GPUZ!!!1x!!!It would be an 8600 not a 8800 that way...;)
As for the 2nd PSU try to fit it under the VGA like in the bottom of the case.I ve done it once and it fitted and u ll route the power cord through one expansion slot...
And then cut the cables from the 2nd psu keeping only the ones u use and from the 24pin only the green wire and a ground...U ll be able to close your case then;)

nah the pump would be in the way of that position and the pump is also to wide for this case.. so its side off till the new case

mangoSiWow, all those wires. Be sure to post it again when you're done with it. What's up with that black sys fan in the middle of yr case?

well as the side is missing it gets no air flow across the memory etc so i have the fan there temporary lol like the rest of the lash-up

I voted 10/10 because:

Looks kool imo. Seldom will you see a clutter let alone a cluttered water cool system. ^^