Self Reported Power States
SSDs in general save energy by switching between different power modes depending on how busy they are. When working hard, they use more power, when idle, they go into low-power or sleep states to save energy. These modes help the SSD balance performance and power consumption, but since the reported power figures are not always accurate, we conduct our own tests to verify real-world behavior.
Manufacturers define the values in the NVMe Power States table and, based on internal estimates or lab testing, store them in firmware—not standardized measurements. These values, like max power and latency, aren't verified by any third-party body and may not reflect actual behavior. They're often derived from worst-case scenarios, simulations, or controller configuration limits.
| NVMe Power States Configuration |
|---|
| SSD | SSD Sandisk DC SN861 7.68 TB |
|---|
| Controller | FADU FC5161 |
|---|
| NAND Flash | Sandisk 3D eTLC BiCS6 512 Gbit 162-Layer (FXZ5 512G) |
|---|
| Firmware | RH110017 |
|---|
| Caution Temperature | 77°C |
|---|
| Critical Temperature | 85°C |
|---|
| Power States |
|---|
| Power State | Max Power | Active | Entry Latency | Exit Latency |
|---|
| PS 0 | 20.00 W | Active (20.00 W) | 0 µs | 0 µs |
| PS 1 | 18.00 W | Active (18.00 W) | 0 µs | 0 µs |
| PS 2 | 16.00 W | Active (16.00 W) | 0 µs | 0 µs |
| PS 3 | 14.00 W | Active (14.00 W) | 0 µs | 0 µs |
| PS 4 | 12.00 W | Active (12.00 W) | 0 µs | 0 µs |
The SSD features two primary power states, both of which are active and consume a certain level of power. Throughout the analysis, we will determine whether its actual consumption is indeed lower than what is specified in its S.M.A.R.T. data. However, this doesn't mean the drive will sustain that level of power consumption across all workloads, just as a graphics card like the RTX 5090 with its 600 W TDP doesn't constantly draw its maximum rated power.
According to the data reported by the drive, the latencies reported by the SSD are listed as "0," which in practice indicates that they are extremely low. Even though the drive has a 20 W power state, its actual power consumption can often be considerably lower depending on the workload. This suggests that the SSD is configured to switch between these active states almost instantaneously, without noticeable delay. However, when entering deeper sub-power states during idle periods, higher transition latencies may occur. As the table title indicates, these values are based on S.M.A.R.T. telemetry and may not fully represent real-world behavior under all usage scenarios.