I use a Xylem D5 pump with a standalone reservoir, with the pump being powered through a direct SATA connection from a PSU used only for watercooling components and not part of the test system. The pump is controlled by an Aquacomputer Aquaero 6 XT in PWM mode. There is a calibrated in-line flow meter and Dwyer 490 Series 1 wet-wet manometer to measure the pressure drop of the component being tested. Every component is connected to the manometer by way of soft tubing, compression fittings, and two T-fittings that have been accounted for when it comes to the liquid flow restriction in the loop.
Two things to note here. First, the Thermal Grizzly DeltaMate is relatively more taxing on your pump than the average CPU block. This wasn't a surprise given what we saw from the more intricate cooling engine and the ultra-fine fins and thin microchannels employed. Second, it's actually less restrictive than I thought it would be! This might be to do with the parallel split exit after the coolant is done with the cold plate, or perhaps the use of the slightly wider fins and channels on either side of the central section, or perhaps it is to do with the part where this cold plate has fewer fins in total spread across a reasonably smaller area compared to some of the more restrictive blocks. No matter the result, this is a medium-high restriction CPU block that is still quite reasonable when it comes to the pressure drop across it—especially compared to blocks from yesteryear—and it should not be a bottleneck to your standard D5/equivalent pump.