Guys I need support to invent a method for pipe unlocking on R420 which will be applicable on R423 and R480 if i succed to prove what I discovered on my X800XT PE AGP. I need 5 minutes measuring on the R420 from your side and I will be in a position to say is it possible to unlock the pipes or not but I don't have the required information. I need information taken from X800PRO non VIVO or SE AGP.
Look the attached picture and if you are ready to spend 5 minutes in research instead hours in asking how to unlock your core please do the following:
You need multimeter and to disconnect left laser cut if it is connected.
1. Stick the black probe of the multimeter to the GND (one of the middle pins of the external power supply molex-connector). Find the sides of the marked resistors connected to GND for every single resistor and write down the exact position of the "GND-end" on the core hand-drawing. (You should read app. zero ohm on one side of every resistor - which means connection to GND)
2. The black probe of the multimeter remains connected to the GND on the molex. Measure the resisitance for every single enclosed with red or yellow resistor (towards GND) but useing the other end of the resistor which is not connected to GND.
(Use range of 2000 ohm)
Please write the measured results for every resistor (just 8 values) and send them to me on
vgd_new@yahoo.com or post them here:
http://forums.techpowerup.com/showthread.php?t=4971
Thanks in advance for the support
Dolf