Monday, August 1st 2022
NVIDIA GeForce RTX 40 Series "AD104" Could Match RTX 3090 Ti Performance
NVIDIA's upcoming GeForce RTX 40 series Ada Lovelace graphics card lineup is slowly shaping up to be a significant performance uplift compared to the previous generation. Today, according to a well-known hardware leaker kopite7kimi, we are speculating that a mid-range AD104 SKU could match the performance of the last-generation flagship GeForce RTX 3090 Ti graphics card. The full AD104 SKU is set to feature 7680 FP32 CUDA cores, paired with 12 GB of 21 Gbps GDDR6X memory running on a 192-bit bus. Coming with a large TGP of 400 Watts, it should have a performance of the GA102-350-A1 SKU found in GeForce RTX 3090 Ti.
Regarding naming this complete AD104 SKU, it should end up as a GeForce RTX 4070 Ti model. Of course, we must wait and see what NVIDIA decides to do with the lineup and what the final models will look like.
Sources:
@kopite7kimi (Twitter), via VideoCardz
Regarding naming this complete AD104 SKU, it should end up as a GeForce RTX 4070 Ti model. Of course, we must wait and see what NVIDIA decides to do with the lineup and what the final models will look like.

121 Comments on NVIDIA GeForce RTX 40 Series "AD104" Could Match RTX 3090 Ti Performance
So you are telling me that TPU was able to run the same Raytraced test to measure power on GTX 1630?? You need to read the TPU review methodology properly. If you lazy to read it, It says Gaming: Cyberpunk 2077 is running at 2560x1440 with Ultra settings and ray tracing disabled. We ensure the card is heated up properly, which ensures a steady-state result instead of short-term numbers that won't hold up in long-term usage.
www.techpowerup.com/review/nvidia-geforce-rtx-3090-ti-founders-edition/37.html
No matter what how Nvidia fansboys trying to spin it Ampere is inefficient. Let me give you a example,
Here we can see Vega20 to Arcturus same node with new hardware matrix unit and 1.73x FP32 performance, same TBP. Where GV100 to GA100, TSMC's 12nm to 7nm(12->7-60% power reduction), only 1.38X FP32 performance, 50W more power. If Ampere were efficient then TBD would have been lower or same. But that does not happened. TBP rose which means one thing Ampere is not efficient.Highly binned A4000 will efficient same as Vega Pro 64 is efficient then the consumer version. Original Vega can run on 150-180W when under volted. So can we say that Vega was efficient and all nvidia fans who dump on Vega are dishonest propagandist.
Edit: Looks like @Beertintedgoggles already pointed out the power consumption testing part.
400w for 3090 ti performance would be fine for me, a bit undervolting and boost rate limit for finetuning. 12 GB Vram is ok for the next 4 years, disliked the 8GB 3070 and 10GB 3080.
www.techpowerup.com/review/asrock-radeon-rx-6950-xt-oc-formula/37.html
The numbers are top loaded with RDNA2 cards.
He accurately leaked the raw layout of all Ampere chips and that it was using Samsung more 1.5 years before launch. That was the most impressive leak imo.
He also leaked TSE scoresback then for GA102 just like he did this time.
I'm pretty sure those SKUs were being tested. They just didn't release. Companies test many potential products that never release
But let's keep in mind that we won't see the real world power draw until the final products are here, and engineering samples commonly have higher power limits.That's because the vast majority of "leaks" are not leaks at all, just random nobodies on Reddit, Twitter or YouTube pulling numbers out of thin air.
The core count of the chips is set >1 year in advance (before tapeut), the only things that changes once the chips are done are how many of them are enabled, clock speeds, TDP, price etc. If you employ this knowledge you can expose most of fake ones. Just look at the track record of your favorite leakers; if they lied in the past, then they are full of s*** and they shouldn't be trusted again.
Also part of what makes Ampere look bad is the absurd power consumption if Microns G6X memory. Had they used regular G6 even on the top end models the power consumption would have been more favorable.
Still today, buyers are focusing on arbitrary specs, because at the end of the day, we all know specs is what makes someone cool, not actual performance.
(sarcasm)
Unigine Superposition 1080p High:
- 60% TDP = 10060 points, 105W 1675MHz
- 75% TDP = 10920 points, 125W 1785MHz
- 85% TDP = 11300 points, 145W, 1830MHz
- 100% TDP = 11530 points, 170W, 1890MHz
- 110% TDP = 11740 points, 180W, 1935MHz (PerfCap = VRel)
Comparing 60% against stock, it's 87% of the performance for only 62% of the total board power.Comparing 60% against an OC, it's , it's 86% of the performance for only 58% of the total board power.
I haven't even bothered undervolting yet. It's inaudible under load set to 75% in afterburner and I'm only losing 5% of the stock performance for that privilege.Are you limited to low-profile? If not, just buy a dirt-cheap 3060 and run it at the lowest power limit you can. This Palit goes down to 55% which ends up drawing a fraction over 90W board power. With the patience to undervolt and tune you can probably get >1700MHz boost clocks from under 100W.
(Now with supplies getting better, there could be opportunities to get a good card at discount.)
But I do wonder though, how does this affect the frame rate consistency?Undervolting is a little more "scary" though. Is it really worth the risk of crashing during gameplay or movies?
I would think that with 25% of the TDP shaved off, the cooler should be easily capable of cooling a card fairly silently, even if it was a higher TDP card than this.
The A2000 is 75W, slot-powered, and likely binned silicon picked for efficiency.
If you're truly after efficiency in the sub-100W range, you can actually go AMD, because raytracing is kind of irrelevant on these lower-end cards so AMD's disadvantage also becomes irrelevant.
An RX6600 seems to have a lot of voltage margin out of the factory, it's pretty likely that you can reduce voltage by 150mv without any consequences, leading to a ~30% drop in TDP at the default clocks. If you give up a couple hundred MHz then Reddit undervolting adventurers prove that a 75W RX6600 should be able to run at 2.3-2.4GHz which likely puts it quite a bit ahead of a 3060 running at the same 75W.
I can for example say that i now pay same or more during the summer that use used to pay during the winter in the coldest months.
The boost algorithm is primarily power-limited anyway. For every Ampere card I've ever tested, PWR and VRel are the only reasons I ever see, so the clocks of your GPU under normal use are always going to be bumping up against a software-defined power ceiling or voltage ceiling.
If you lower the power ceiling by setting a reduced power limit, the behaviour is exactly the same. The only possible side effect is that you're less likely to get voltage limits influencing the boost algorith, which (if anything) is likely to make the boost clock more stable, not less stable. I suspect the difference is so tiny that it'd be lost in run-to-run variance, but if anything, I'd expect an underclocked card to be more consistent, not less.
if mainstream Ada cards jump up to 18-20 gbps GDDr6, then they can easily handle 3070 at 192 bits,. The double-density means the 4070 gets a 12GB bump, and the rest of the lineup jumps to 16GB or more.
I expect that they will want to maintain the current 3070 TDP of 225w for 4070, and with that massive rumored performance bump (3090), you're going to have to cut power in unique ways (by cutting the memory devices in by nearly 1/2, that's a good start!)
In 1990, when I was learning about electricity in school, we had a particularly stable period lasting most of a decade where electricity in the UK cost 5p/KWh. Inflation since 1992 is almost exactly double, but energy costs have increased almost 7x and will soon be 9x more. That's basically a 4.5x increase in real cost over the last 30 years, adjusting for inflation, and the bulk of that increase has been very recent.
Source:
assets.publishing.service.gov.uk/government/uploads/system/uploads/attachment_data/file/1005772/Electricity_since_1920.xls
Admittedly, this silly country did a big messy brexit-shaped shit on the carpet, so things might not be quite so bad elsewhere in Europe.
Do we understand the context now?Wow. Just wow.
You know the old saying: Ignorance is bliss..I don't care? 256bit or they can take a flying leap..Rendering an opinion without historical context and technological understanding is unadulterated ignorance.