Monday, August 1st 2022
NVIDIA GeForce RTX 40 Series "AD104" Could Match RTX 3090 Ti Performance
NVIDIA's upcoming GeForce RTX 40 series Ada Lovelace graphics card lineup is slowly shaping up to be a significant performance uplift compared to the previous generation. Today, according to a well-known hardware leaker kopite7kimi, we are speculating that a mid-range AD104 SKU could match the performance of the last-generation flagship GeForce RTX 3090 Ti graphics card. The full AD104 SKU is set to feature 7680 FP32 CUDA cores, paired with 12 GB of 21 Gbps GDDR6X memory running on a 192-bit bus. Coming with a large TGP of 400 Watts, it should have a performance of the GA102-350-A1 SKU found in GeForce RTX 3090 Ti.
Regarding naming this complete AD104 SKU, it should end up as a GeForce RTX 4070 Ti model. Of course, we must wait and see what NVIDIA decides to do with the lineup and what the final models will look like.
Sources:
@kopite7kimi (Twitter), via VideoCardz
Regarding naming this complete AD104 SKU, it should end up as a GeForce RTX 4070 Ti model. Of course, we must wait and see what NVIDIA decides to do with the lineup and what the final models will look like.

121 Comments on NVIDIA GeForce RTX 40 Series "AD104" Could Match RTX 3090 Ti Performance
10752 Cuda 256 bit and 7680/192 bit cards make perfect sense, very proporional and linear scaling. if the chances for defective channels are so high nvidia should have designed it with 256 bit just like 2070. but why so much cutting, probably 192 bit can allow for a low production cost and low hash rate.3070 starting at only 499 compared to 2080 Ti 1199 is what we know.
All we get is a shrinked version of 3090 Ti. At 98 Mtr density the 300mm2 die packs 29000M transistors.
unfortunately for N7 and N10 it says AND, so it's probably still OR, a mistake was made.
To 192 bit bus. The higher the frequency, the more problems with a broad bus. They calculated, how many resources are spent for higher clock rates, how many for 160/190/256 bit. It was cheaper to gain performance, using higher clock rates/memory compression technologies/cashing, than invest in stabilizing 256 bit bus/PCB production. These are gaming cards, not hpc, where other prices are paid.
And do you think this will matter compared to people using induction cooktops which typically draw 6-7 kW in bursts? Or people charging their cars?Undervolting is a very short-sighted "solution", as the silicon ages it will become more unstable. Computers have enough annoyances as it is, I'm not going to introduce new problems like that. ;)
What's the point of having power hungry gpu?
We'll have one in our basement, but town will have total of millions of cards.
Once you know the ballpark for undervolting, it takes a minute. I just bought my nephew a 3070 and it took me 1 minute to set up an undervolting profile for him, lowering stock power consumption from 210W down to 120W, my nephew has been playing with the new 3070 for 3 days now and no complaint about instability. Basically it can be set&forget.
Of course RT ON increases power draw - anyone running an undervolted Ampere card (for various reasons) will easily notice that enabling RT adds a huge amount of power consumption, as all of a sudden a large portion of the chip now is active. There are literally a couple billion transistors now consuming power (while otherwise they sit idle/inactive).
Anyone can test this easily for themselves.
Example:
- RT Off, card is capable of 1900mhz within a set power limit.
- RT On, the card can lose 100mhz easily to stay within that same power limit.
That is because the gpu needs to lower the voltage and therefore frequency. Power scales quadratically with voltage - just look at any voltage/frequency graph that also shows power consumption.
The question was whether the power grid would handle it, I mentioned some other loads which are much more concerning.
And how big is your town if there are millions of cards gaming at the same time? ;)Wow, no complaints in three days and you think it's stable.
Microchips have a safety margin to account for chip variance and chip degradation. If you remove this margin, then over months or years it becomes gradually more unstable. I'm fine with people taking a conscious and informed decision to experiment, but undervolting should never be a recommendation to cope with power draw, as it will lead to a lot of undefined behavior which is hard to troubleshoot for even most enthusiasts.
My town is 2.6x bigger than Toronto. With population more than 20 of the European countries.
Our province is around the size of Spain
There are blackouts specially in summer in many countries because people use more AC or whatever reason. You don't want to add 800w salt of gpu to the injury.
Undervolting would greatly extend the lifetime of your GPU since it removes clock fluctuation (which is really bad for VRM), reduce power and thermal (which are main factors of chip degradation).
After undervolting my 3090 for 1.5 years, I think I know the ballpark for undervolting Ampere, and I left quite a good margin for stability (I only spent a minute setting up the undervolt LOL)
If RT is needed, the tradeoff is positive, the frame rates would go significantly down, if you use cudacores for raytracing instead of throttling cudacores and activate rt-cores.If clock speed, caching, compression are maxed out, its quite possible, we will see broader memory bus again. It really depends on what technology is advancing rapidly. PCB production is conservative, slow advancing.
He says 16gb he say 12gb. these are his accurate 4080 rumors. :toast:
The whole thing will be announced 15 days after his tweet, and he still doesn't know the vram.
I guess other European countries have seen major price increases, others lower than ours, others maybe even higher.
This war affects Europe, in a very very significant way.